Stevenson Overall Indigo "Slinger" Denim Jacket

December 08, 2016

Stevenson Overall Indigo

The Stevenson Overall "Slinger" jackets are inspired from some vintage ranch jackets but in a modern look.

The front body features V-shaped pleats on both sides, reinforced with chest pockets and rivets for a distinctive design. Positioning of the top button is low, allowing the collar to open and structure into a ‘horizontal collar’. The front yoke is sewn diagonally, using flat felled stitching with 5.6mm twin-needle head, and all lock stitching is done with a narrow width for a clean finish. Pocket flaps feature a curved stitch design. Backside features vertical pleats with a large buckle-back and each end is inserted between the pleats and sewn.

The "Slinger" jackets are some "Next Level" jackets that you will love to wear quite often and enjoy the look of ageings!

Click here to buy





How We Measure

Pants and Shorts

Waist:

With the major buttoned up open the jeans and lay them flat like shown. Measure from the front where the major button closes to the back belt loop. Then double this measurement to achieve the waist measurement.

The way we measure is different from 'Side to Side', If you are not used to our method you should downsize by 1 inch.

For example, side to side measurement for The Flat Head 3002 waist is 28inch and using our method 29.25 inch.

Front Rise:

With the jeans lying flat measure from the crotch bar tack to the top of the waistband. 

Back Rise:

Spread out the crotch so the bar tack is visible, then measure from the crotch to the top of the waistband.

Thigh:

One inch down from the crotch measure flat across to the other side.

Inseam:

Flatten the leg and measure along the inseam from the crotch to the leg hem. 

Leg Openning:

Measure straight across the hem from side to side.

Tops

Shoulder:

Lay flat then measure from the shoulder's edge to the other shoulder's edge.

Chest:

Lay shirt flat and measure from pit to pit.

Sleeve length:

With the sleeve flat measure from the shoulder to the cuff.

Arm hole openning:

Measure from the shoulder down to the pitt.

Vertical length:

With the shirt facing down, Measure from below the collar to the bottom hem.