It's been a while since we sold out that "W.O.L.F" pin. Here we are back with our friend Dean and his new "Metal Vader" pin set. The set is inspired by the Darth Vader of Star Wars. Taking the classic silhouette of Darth Vader with "Deanism" design, the pins go with some crazy details. Since the design is so complicated, this is actually the limit of pin manufacturing (according to Dean, he was rejected by 10 factories). All of them are made out of fine metal with top quality in limited quantity.
These pins are in a relatively large size. But it is the notorious Mr. Vader, you know who's the "Big Poppa"!
Click here to buy
With the major buttoned up (i.e. the top button) open the jeans and lay them flat, like shown. Measure from the front where the major button closes to the back belt loop. Double this measurement to find the waist measurement.
The way we measure the waist is different from the 'Side to Side' technique. If you are used to the 'side to side' technique you can roughly roughly downsize by 1 inch.
For example, 'side to side' measurement for The Flat Head 3002 waist is 28inch and using our method measures at 29.25inch.
With the jeans lying flat measure from the crotch bar tack to the top of the waistband.
Spread out the crotch so the bar tack is visible, then measure from the crotch to the top of the waistband.
One inch down from the crotch, measure flat across to the other side.
Flatten the leg and measure along the inseam from the crotch to the leg hem.
Measure straight across the hem from side to side.
Lay flat then measure from the shoulder's edge to the other shoulder's edge.
Lay shirt flat and measure from pit to pit.
With the sleeve flat measure from the shoulder to the cuff.
Measure from the shoulder down to the pitt.
With the shirt facing down, Measure from below the collar to the bottom hem.